Coaxial Cable Joint Operation Process And Manufacturing Method

First of all, it is necessary to prepare the equipment and tools for making coaxial cable joints, mainly including Qubing hand press, wire stripper, scissors, diagonal pliers, wire stripper, solder, resistance welding equipment, network analyzer, intermodulation Testers, torque wrenches, high pressure testing equipment, injection molding equipment or hot air cylinders, etc. The operation process includes: punching the insulator into the main body, entering the shell, cutting the wire, stripping the wire, dipping the tin, welding the center conductor, welding the outer conductor, the mesh test, the intermodulation test, the high voltage test, injection molding or blowing the heat sink.

Refer to the operation process to introduce the production method of the coaxial cable connector. During the assembly process, keep the environment clean and tidy, and pay attention to wearing finger cots; keep the inside of the joint body free of impurities, oxidation, copper, bumps, etc.; keep the wires free of damage, and pay attention to whether the stripping size is accurate; Note that there should be no strong airflow blowing through the surrounding environment, and the welding time should not be too long, and it can be welded again after cooling; it is best to use a torque wrench during the test, and the intermodulation test can be performed by using a rubber hammer to strike the solder joint back and forth (until the test is completed. )dynamics test.